You are installing an IDE hard drive that will be your boot drive Which is the correct order of steps that need to be followed?

(A) jumper properly, auto-detect(or configure manually) in CMOS, low level format, high level format, partition

(B) jumper properly, auto-detect(or configure manually) in CMOS, partition, high level format with / s switch

(C) jumper properly, partition, auto-detect(or configure manually in CMOS, high level format with /s switch

(D) jumper properly, auto-detect in CMOS, regular format

Share:

Note: if you think the answer of the question is wrong or changed with time, Comment below with right answer or its better to contact us via “Contact us page” for quick update. We will really appreciate your contribution.

Comments:

Leave a Comment

Your email address will not be published. Required fields are marked *